Try to angle the holes upward if you can. Let the glue set.ĭrill three holes along top of the end of the cap, three along the center and three along the bottom. Place PVC primer and glue onto the cap to glue it in place. Push the closed end of the cap 1/4 inch into the hole. Cut out the inner part of the traced half-circle using a drill fitted with a 1 1/4-inch circular drill bit. Trace along the top side of the cap where it touches the PVC pipe. The bottom of the cap should extend 3/10 inch past the bottom of the 4-inch PVC pipe. Take the 1 1/4-inch cap and place it beneath the bolts on the conduit, leaving plenty of space on the conduit between the bottom bolt and the top of the cap. Place a bolt through each hole, then a washer, followed by a nut. The hole needs to go through both the conduit and PVC pipe. Measure 1 1/2 inches up from the bottom of the PVC pipe and make another dot under the first one. While holding the conduit in place, measure 2 inches up from the bottom of the PVC pipe and mark a dot with a felt-tip pen. Hold it in place and measure 1/2 inch below the collar. The short end of the conduit's bottom should extend 1 inch past the bottom of the 4-inch PVC pipe. Take the shaved conduit piece and set the flat, cut edge onto the combined PVC pipes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |